Cold Air Intake System

Fits all Emira V6 cars. 

Includes all needed components for installation:

• ITG High Flow Foam Filter with custom spec'd spun aluminum airbox (500hp rated)
• Silicone airbox inlet coupler
• Specially sized aluminum MAF housing with hardware in a powder coated finish
• Specially made MAF to Throttle Body silicone coupler 
• Laser cut, powder coated airbox hanger bracket with rubber trim. 
• Cable ties for maf sensor harness
• Appropriate clamps and hardware 

Features: 

• These kits utilize the proper size air meter housing so no recalibration is needed, it is a simple bolt on and go type kit. 
• Uses a 500 hp rated semi sealed type airbox for optimum airflow and pulls air from the factory side inlet so you always have clean, ambient airflow. 
• Oiled type foam airfilter performs well even when dirty!  They also provide much better airflow than the oem paper type filter or the aftermarket cotton gauze type.
  
• Sheds weight!   Stock airbox system is large and clunky, this new system is a clean simple design and weighs less than the oem system
• The sound is awesome!!   Wide open throttle and rev-matched downshifts sound particularly great with this system. 
• Improved throttle response 
• Dyno proven HP & TQ Increase!   12hp when installed along with our decat pipe and rear section exhaust.    

Helpful install video below.  

 One small note not mentioned in the video --- There are four little slits on the top portion of the laser cut hanger bracket, those are for zip-tying the wire harness back up into position above the air canister to keep roughly the same routing as oem.